Page 1 of 1

Solo/Mute Layer

PostPosted: Thu Dec 27, 2012 4:15 pm
by merCUrium
Sometimes it would help to mute a specific layer, or solo (=mute all others).
Most times this would be usefull for programming, whether to show some details by hiding all other stuff, or to program a specific effect etc.

Of Course one could use the opacity, but you would have to select multiple layers, pull the opacity down and make the opacity not an active value. and if you click reset, to undo the programmed effekt you have to start over again.
Maybe this could be done via little "sub-icons" on the device-viewe-tab.

Re: Solo/Mute Layer

PostPosted: Mon Jan 14, 2013 4:11 pm
by Markus Zeppenfeld
Hi!

This is a question we have heard for some time.
At the moment it would be a workaround to deactivate the outputs within the inspector. If the layer is not part any output, it is therefore muted.
http://www.coolux.de/root/downloads/sup ... pector.htm

Solo would be more difficult to realize with the output settings. :-)

I'll check again if it is like this on the list.

Thanks for your suggestions.
Markus