Page 1 of 1

Layer Output Routing in WD

PostPosted: Fri Nov 13, 2015 12:56 am
by JustynR
I would love it if someone were to say that this is already possible!!

I need a way in the current show that I'm working on to un-check 2 layers from just a camera for a cue, then re-check them for the same camera for the next cue.

Right now I have to manually click on the layer, disable the camera checkbox, quickly go to the next layer and do the same... then hopefully not forget to undo that in the next cue.
It's sloppy, slow, and I can't guarantee that it'll be done right for the next month after I leave. (I'm only programming, not operating.)

Is there a way to do this through PB or WD right now?
If not, can I have this for... tomorrow?

Thanks!

Re: Layer Output Routing in WD

PostPosted: Sun Nov 15, 2015 3:22 am
by Dennis Kuypers
Hello Justin,

I'll look into it, but it won't be available tomorrow :D
It might be that this is simply a question of the right licence. If you need a different routing then a different layer can be used.

Regards
Dennis