Page 1 of 1

Softedge blending plus warping issue

PostPosted: Sun Apr 01, 2012 9:41 pm
by egoy
hi to everyone.
Ive got an issue with regards to warper of the PB.heres the scenario, I need to pixelmap a stage set with different elements in front of the projected surface. I need to use two projectors blended with softedge to achieve a wide pexelmapped stage set. Now for my first question is it possibe for me to view simultaneously the wireframe of the two outputs of Pandora box server when I use the warper? because if i click "stretch left " I can only see the wireframe of the first output but not on the second one, and its the same if I click "stretch right.the reason for this is I need to align and match the wireframe of the each outputs in the overlapped section

Re: Softedge blending plus warping issue

PostPosted: Sun Apr 01, 2012 10:33 pm
by JustynR
I am assuming you're doing this in the Warper,

Simply start the Warper a second time.

I hope that does it,

J

Re: Softedge blending plus warping issue

PostPosted: Mon Apr 02, 2012 4:02 am
by egoy
ok will try that. so "start again the warper the second time " means to close and open the warper back again without restarting the server?

Re: Softedge blending plus warping issue

PostPosted: Mon Apr 02, 2012 4:28 am
by JustynR
No, by that I mean when you have one warper open and filling one screen, click "Warper" again to start a second Warper program running.
Then you should have 2 tool windows. You can then put that on your other display.

Re: Softedge blending plus warping issue

PostPosted: Thu Apr 05, 2012 3:07 pm
by egoy
hi justynR thanx for the reply, Ill try that as soon as I reached the office,ill let u know how it goes..

Re: Softedge blending plus warping issue

PostPosted: Wed Apr 11, 2012 2:33 am
by egoy
it works thanks..