Page 1 of 1

Warping with several meshes

PostPosted: Fri Aug 02, 2013 7:29 am
by loggyskin
Hello?
I has a problem in PB Warp.

1. Here's a projection plan
test1.jpg


One projector should cover two faces that have different angel.

2. Making two meshes in PB Warp
test3-1.jpg


I made two meshes using Zoom,Aspect, X Off in PB Warp
It looked good.

3. Using PB manager with the X file.
test2.jpg

This's Preview. (Fullscreen mode has same problems)

Both sides of the image were broken.
I think the value of "X Off"' in PB warp made the problem or bug.

Is there any answer or tip?

Thanks

Re: Warping with several meshes

PostPosted: Fri Aug 02, 2013 9:37 am
by Dennis Kuypers
Hello!

In my opinion it looks more like a graphics card problem. Does that happen only with that one object file (if so, please mail it to support at coolux.de)? Did you try different media?

If using nvidia, check if you are using driver version 320. This version has a couple of bugs and you should downgrade to an older driver version!

Best regards
Dennis