Page 1 of 1

rotate and block axis X Y Z not work

PostPosted: Thu Aug 22, 2013 12:52 am
by francomaria
Hi guys,
in new warper (combined with v5.5 pbox) I have notice that not working in rotate mode. (this in warper 3d and 2d)
In warper 3d when press X Y and Z for used an only axis not work, always all axis are at work.

This is a my problem or do you have notice of this?

Regards

Franco Maria

Re: rotate and block axis X Y Z not work

PostPosted: Fri Aug 30, 2013 11:59 am
by Martina Protze
Hi Franco,
thanks a lot for the report
the issue with the non-rotatable mesh points and the inverse working lock function is known and fixed. The fixes will be available in the next version. Please go back to the last revision contained in Version 5.3 if you need these functions. Please contact us if you urgently need the fixed beta version. In your case, Ricky from your distributor Molpass has contacted us already. Please let him know whether you need the version and I will send it to him.

Again, thanks for the feedback