Page 2 of 2

Re: Split LED Wall Tearing

PostPosted: Wed Nov 08, 2017 12:50 pm
by Thomas Mrozek
Hi,
If you turn on Mosaic mode and sync card setup is correct there should be no issu between 2 outputs on the same machine.
The only way to get it out of sync (as long as containers are lock to time) is to drive 2 different layers on each output and exceeding the performance limit of the server. Please refer to our performance specs.
cheers
Thomas

Re: Split LED Wall Tearing

PostPosted: Fri Nov 10, 2017 3:32 am
by Justyn Roy
I've also found you'll get better results if you map the outputs beside each other.

For example, if you have a 1200 pixel wide panel beside another 1200 panel - start the first output at 719 and not at 0, that way pixel 1200 and 1201 are directly beside each other in the graphics card.

It was many years ago I tried this & I didn't have Mosaic to try it with, just sharing some better results I had.

Re: Split LED Wall Tearing

PostPosted: Fri Nov 10, 2017 7:14 pm
by Dennis Kuypers
Thomas Mrozek wrote:Hi,
If you turn on Mosaic mode and sync card setup is correct there should be no issu between 2 outputs on the same machine.
The only way to get it out of sync (as long as containers are lock to time) is to drive 2 different layers on each output and exceeding the performance limit of the server. Please refer to our performance specs.
cheers
Thomas


To elaborate on this: If you turn on mosaic then Pandoras Box effectively only sees one output, so it can not introduce tearing between outputs if playing one video across both screens. In this case it has to be a problem down your signal chain or display devices.

Regards
Dennis