Page 1 of 1

Warp bug: half image not shown

PostPosted: Wed Aug 01, 2018 2:00 pm
by a.borelli
Hi everyone!

I am Andrea from Italy.

Currently I am working on a multi projection on the inside-of-a-reverted-cone shaped auditorium - a rather strange and complex place, I know.

I am using a Pandora's Box Quad Server PK3 (Windows 8 OS) with software version 6.1.0. Each output is working at 1920x1200@59,95Hz, flowing through a HDBT transmitter (Kramer PT-580T) to four Epson EB-L1100U.

Since the complex surface I need to work on, I warped all four outputs. I saved the project, turned off every manager and server. As soon as I turned it on again, the image was showing a rather strange bug.

The upper part of the warped outputs was completely black, the lower part was shown as it had to be. The problem is in facts easy to fix: as I open the warp project and touch any mesh, the image istantly gets back completely. I need to do it for every output, obviously: each project "reloads" only its portion.

My problem is that this setup need to be permanent and I won't be here anymore as soon as it's done. Those who will operate cannot reload every warp project each time the auditorium needs to be used.

Am I doing something wrong or it is a bug?

Let me know what are your suggestions!

Thanks in advance.

Re: Warp bug: half image not shown

PostPosted: Wed Aug 01, 2018 3:48 pm
by Thomas Mrozek
Hi Andrea,

please try spread the mesh files again (right click folder with mesh files, spread). If this is not successful please contact