Hi,
has anyone tried to connect the widget designer with a siemens Logo over Modbus ? I would like to read Coils ( simple Digital Output) from the Logo in Widget designer. I had tried to set it up but found no Information about Data Type and right settings.
The Logo send the Output to Unit ID 255, Coil 3, Port 502. With other Modbus Tools i can read out the state of the output.
greetings
Marcel
Mdbus with Siemens Logo
Moderator: Moderator Group
Forum rules
When asking make sure to include the operating system and the revision of Widget Designer you are using.
When asking make sure to include the operating system and the revision of Widget Designer you are using.
2 posts
• Page 1 of 1
Mdbus with Siemens Logo
by stage-crew-eventtechnik » Tue May 30, 2023 10:52 am
- stage-crew-eventtechnik
- Posts: 5
- Joined: Fri Mar 07, 2014 10:54 am
Re: Mdbus with Siemens Logo
by Daniel Kaminski » Tue May 30, 2023 4:10 pm
Never worked with a siemens logo, but I did a lot of work with beckhoff Modbus Devices and WidgetDesigner
Modbus has different registers for types of inputs/outputs
digital outputs are normaly 0xxxx
digital inputs 1xxxx
analog outputs 3xxxx
analog inputs 4xxxx
Modbus Port is per default 502
Since I do know nearly nothing about Siemens Logo, can you explain Unit ID 255 and Coil 3?
How do you see the values in other Modbus Tools?
Feel free to contact me directly.
Daniel
Modbus has different registers for types of inputs/outputs
digital outputs are normaly 0xxxx
digital inputs 1xxxx
analog outputs 3xxxx
analog inputs 4xxxx
Modbus Port is per default 502
Since I do know nearly nothing about Siemens Logo, can you explain Unit ID 255 and Coil 3?
How do you see the values in other Modbus Tools?
Feel free to contact me directly.
Daniel
--
Daniel Kaminski
Pandoras Box Expert
Daniel Kaminski
Pandoras Box Expert
-
Daniel Kaminski - Posts: 1071
- Joined: Tue Jul 22, 2008 10:55 am
- Location: Herten, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests