I have a simple countdown clock timer in my WD project. It is as follows:
Clip Remaining Time Input Node ------> Label Output Node -----> Label
For some reason the clip remaining time node will not store the information. When I configure the node for sequence, site, device. (i.e. sequence 4, site 4, device 4) it works fine. I save the project and have also tried to save copies.
When closing WD and reopening the configuration data is not saved. It shows up as configured sequence 4, site 0, device 0. It does this every time. Once I reconfigure it works fine.
Is this by design or a bug?
Thanks!
Jay