Page 1 of 1

Clip Remaining Time Node Not Storing Info

PostPosted: Tue Aug 22, 2017 4:57 pm
by jaykoller
I have a simple countdown clock timer in my WD project. It is as follows:

Clip Remaining Time Input Node ------> Label Output Node -----> Label

For some reason the clip remaining time node will not store the information. When I configure the node for sequence, site, device. (i.e. sequence 4, site 4, device 4) it works fine. I save the project and have also tried to save copies.

When closing WD and reopening the configuration data is not saved. It shows up as configured sequence 4, site 0, device 0. It does this every time. Once I reconfigure it works fine.

Is this by design or a bug?

Thanks!

Jay

Re: Clip Remaining Time Node Not Storing Info

PostPosted: Wed Aug 23, 2017 9:18 am
by Mike Mengen
Hi Jay,

that seems like a Bug. I'll forward that to our Developers.
For Bug reports you can also write a mail to support.pandorasbox@christiedigital.com

Regards
Mike

Re: Clip Remaining Time Node Not Storing Info

PostPosted: Wed Aug 23, 2017 4:16 pm
by jaykoller
Thanks Mike,

Let me know if you need the project file, but I was able to replicate it on another machine so I don't think it is project specific.

Jay