Hi,
I am using the new modbus device fonction (WD 6.0.4) to interact with an ADAM 6066.
When the Widget is loading/opening the modbus device isn't connect automaticly.
I have to manually re-connect the device each time I open WD.
Is their a script that we can run at startup to make the connection ?
Thanks & Regards
Julien
Modbus Device connection
Moderator: Moderator Group
Forum rules
When asking make sure to include the operating system and the revision of Widget Designer you are using.
When asking make sure to include the operating system and the revision of Widget Designer you are using.
3 posts
• Page 1 of 1
Modbus Device connection
by julien » Thu Jun 14, 2018 8:00 pm
- julien
- Posts: 4
- Joined: Thu Mar 12, 2015 9:24 pm
Re: Modbus Device connection
by Dennis Kuypers » Fri Jun 15, 2018 1:30 pm
Hello Julien,
If you named your device for example "MyModbus", then you can simply do MyModbus.Connect() (or Reconnect, which is the same as a Disconnect followed by a Connect)
Regards
Dennis
If you named your device for example "MyModbus", then you can simply do MyModbus.Connect() (or Reconnect, which is the same as a Disconnect followed by a Connect)
Regards
Dennis
-
Dennis Kuypers - coolux Germany
- Posts: 771
- Joined: Thu Jul 05, 2012 12:18 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests