Page 1 of 1

master/client start commands naming in WD6.0.5

PostPosted: Mon Oct 01, 2018 5:09 pm
by dchelnokov
Dear All,

I noticed that there is a little command naming inconsistancy in WD 6.0.5, that slightly confuses when you try to run a Master or Client remotely:
WD allows you to start Master remotely if you type the command like "PbStartMaster("ip address"), while the client's command spells with the upper-case 'B': PBStartClient("ip"). Otherwise WD doesn't send any commands.
Am I the only one who experienced this? :roll:

OS: Win 10
Program: Widget Designer Unlimited v6.0.5