Net link
Posted:
Wed Nov 17, 2021 2:01 pm
by svarga
Hello,
I am using PB 8.2.0, and WD 6.5.2 along with NET Link with Relay input module
How do I setup the initial address of NET link for it to start receiving data to WD NET link node?
Thank you,
Stjepko Varga
Re: Net link
Posted:
Wed Nov 17, 2021 10:49 pm
by justyn roy
Hello,
Please look at this page in the manual to get started.
If you have any other issues, please reach out again!
https://christiepandorasbox.com/root/downloads/support/Documentation/Helpfile/#net-link-software.htm
Re: Net link
Posted:
Thu Nov 25, 2021 1:49 pm
by svarga
Thanks for your reply,
I entered a new address in WD NET Link node, but I am not receiving any input from NET Link. I also can not ping NET Link with the new address, nor can I see it using arp-a.
How can I check that the address really has changed? What is the correct way to check that NET Link is "alive"?
Best regards,
Stjepko
Re: Net link
Posted:
Thu Nov 25, 2021 5:28 pm
by justyn roy
In this link, you can find the default address if you've done a factory reset on the device.
Have you tried this?
Netlink Node PropertiesIf you have and need more assistance, please contact Pandoras Box Support:
support.pandorasbox@christiedigital.com