projector twinkle off

[mhdkh]

Hello Coolux,
I'm facing a problem that projectors seem to twinkle or disconnect for a second every 10 seconds then they come back to work normally, i don't think it's a technical issue in the projectors devices because that happens to the screens also if I link them to the DVI outputs.
Is there any idea about any settings could cause such a problem, ?

thanks in advance,

[Daniel Kaminski]

sounds like a bad cable or connector.
For some reason the projector looses sync.

Can you describe your setup and the cabling?

Daniel

[mhdkh]

thanks Daniel,
I restarted the server and set the resolution or the QUAD DVI to 1280x1024@60p, then two of the three projectors i use aren't disconnecting anymore, but the third still disconnects for a second every while,.. so i don't think there's a problem in cabling also, and still cannot define the problem exactly..

thanks

[malkuth23]

Are you using the original supplied cables from coolux to go from the Server to the Quad Splitter?
This is very important as no other cable type will work.

[mhdkh]

not actually, i'm gonna try to use another cable until I get coolux cable.

thanks