Fullscreen in secondary output problem -PlayeurPro[RESOLVED]

[gestin]

Hello,

I'm run Pandora box Playeur pro in laptop ACER Aspire 5942G ( Win 7 Pro 64B - 6Go RAM - ATI mobility radeon HD5650 1Go) I use the same resolution and frequency for both screens

With the 5.5 Rev 9926 the fullscreen mode works as well on the screen of the laptop on the second output.

With 5.7 Rev 10085 and Rev 10349 without changing the configuration of the graphics card, only the screen on the laptop full mode works. On the second screen I still get a black screen.

Is there something I should have done wrong or a new incompatibility related to version 5.7?

Thank you for your reply

François Gestin

[Benni_M]

Hello,

have you changed your Output Port in the Inspector of the Output layer?
It's a bit different than in V5.5

Greats,
Benni

[gestin]

hello,

Thank you for the information that is actually in the inspector of the output that was not well selected.
A new option that I had not seen.

The issue is resolved.

again thank you

[wijnand]

Hi, I'm stugling a bit with my setup. I've a PlayerSTD dongle (Rev10386) with GTX760 graphics dual output. Both are identical configured. I just want to have one screen on the beamer (the primary) and one screen to be the "manager"(the second screen). Now, when entering full screen mode, the beamer is ok, but my "manager" display is going to black.
How can I solve this?

Regards,

WIjnand

[Dennis Kuypers]

Hey,

you need to select "Full screen is single", so that only one display gets into fullscreen.

Regards
Dennis

[Dennis Kuypers]

Hey,

you can select "Full screen is single" (Configuration Tab -> Render Engine), so that only one display gets into fullscreen.

Regards
Dennis

[wijnand]

Found it.. Thanks! In configuration, navigate to "renderengine" and check "fullscreen is single".