Page 1 of 1
Media manager
Posted:
Mon Dec 01, 2014 4:32 amby yana
Hi.
Just a quick question.
can we control 2 manager at a same time with and without timecode?
thanks
Re: Media manager
Posted:
Mon Dec 01, 2014 11:00 amby malkuth23
control how?
a bit confused.
timecode is selected per sequence. If you are using a Manager, then each sequence has it's own controls over if it is ignoring,generating, or following timecode.
Why 2 managers?
Re: Media manager
Posted:
Mon Dec 01, 2014 11:08 amby yana
hi malkuth23
1 manager is the main manager will triggered and the other manager is the backup manager.
so we trying to run both manager at same time.
Re: Media manager
Posted:
Mon Dec 01, 2014 12:20 pmby Dennis Kuypers
Hey,
like I wrote in my email you can use 2 SMTPE links to sync up the managers, but that only works for one sequence. The usual way to do this is to use one Widget and start both Managers simultaniously.
Regards
Dennis
Re: Media manager
Posted:
Mon Jan 05, 2015 11:09 amby erica frost
If you use the Widget Designer and have the IP's set to reflect the main and backup manager in the WD IP Config, then the Widget controls both the main and backup manager at the same time.
Re: Media manager
Posted:
Thu Feb 02, 2017 11:34 amby ^nto
Hi,
I would do the same thing without WD, if i set the Backup manager in Backup mode is not possible to control at the same time the timeline?
If I'm using a backup sistem I suppose that it have to follow the main sequence.... why I have to pass from WD??