Page 1 of 1

asio card setup

PostPosted: Mon Oct 01, 2018 2:10 pm
by alverman
good morning,.
I have a usb asio board with four outputs.
I have an audio file on the first audio layer that corresponds to channel 1 and the sound goes out stere0 ..... OK
I have an audio file on the second audio layer that corresponds to channel 2 and the sound, even if it is a stereo track, comes out mono!
Any track on layers 3 and 4, which correspond to channel 3 and 4 of the sound card, are muted.

Why ?
Thanks, Alberto

Re: asio card setup

PostPosted: Tue Oct 02, 2018 9:35 am
by ricky
Hi Alberto,
if you have a stereo audio file on first track the channel 1 is assigned to Left and channel 2 to Right, so the second track in your case has to start from channel 3 (left) to 4 (right).
Check also the "Channel Details" in ASIO configuration section and make sure you have channel 3 and 4 in the output list. If not sometihing is probably wrong with the card driver..

Cheers

Re: asio card setup

PostPosted: Tue Oct 02, 2018 8:34 pm
by alverman
Thanks Ricky :D