50Hz Out at pandoras Box
Posted: Tue Sep 30, 2008 12:37 pm
I just found out that it is a little bit confusing how to set up 50 Hz on two outputs on Pandoras Box. First of all i just could get it really to work is to use RGBHV cables.
When you try it directly in Dual View Mode it will not work properly. The thing is that you have to switch to single output. then set up the custom Resolution in the desired Resolution and Frequency. When the first Monitor is done, you have to switch to the second one also in Single Mode. Also there you have to create a custom resolution. After this is done you can go to the multiple disply setup and switch to Dual mode again. After that i was able to directly setup the desired resolution without a problem.
When you try it directly in Dual View Mode it will not work properly. The thing is that you have to switch to single output. then set up the custom Resolution in the desired Resolution and Frequency. When the first Monitor is done, you have to switch to the second one also in Single Mode. Also there you have to create a custom resolution. After this is done you can go to the multiple disply setup and switch to Dual mode again. After that i was able to directly setup the desired resolution without a problem.