Pandoras Box User Forum

HI

is possible to remote atem studio mixers with widget designer?

thanks

It should be.
Since ATEM reacts on TCP Commands.
I have done it for BM SDI Matrix.

You will propably need to download the SDK to get the commands.

Should not be that hard.

Daniel

hi

i have no idea how to use sdk commans, can you show me an example to see how to do?

thanks

I am sorry, but I do not have the time right now to do that. Maybe someone else in the Forum can help.
Here is a link on how to control the BM Smarthub from WD.

I assume the ATEM SKD will be similar to the Smarthub one.

viewtopic.php?f=4&t=3240

Basically you will have to connect to the Switcher using a TCP Connection. You will have to find out the Port.
After that you can send Commands as RAW Commands to the Switcher. The Smarthub is a good example for that.

Daniel

i think the protocol is not the same , but is it possible to sniff the commands with widget designer pro? is it posible con you tell me how to do that?

thanks.

Widget Designer is not a Protocol Sniffer.
Try wireshark.

there are a tone of tutorials on youtube and in the web.

Daniel

was now someone able to connect and control to the atem switchers?
Would be awesome if this is possible..

I now tried arround 2h with wireshark, casparcg clients and more.. but i have no chance to control the switcher.
The TCP Connection seems to be well, it say's connected and the tcp message tester get some replys with version infos. But all my commands i send get no reply or action on it.

I use V6 of Widget Designer and 7.2 of the Mixer (tv studio hd)

Hi Silasfue, which UDP settings/ports did you use to connect to the Atem?