Interactive floor

[niky]

dear all,
i need very quickly to setup an interactive floor with my WD pro,
this is non a fixed installation...
is there someone that have done something similar before??!
for a distance of 5\6 meter i need only one camera and tracking input tool??or more camera and detection tool?

the goal will be for exemple :
walk on the water and generate wave with the feet ( motion detection tool is correct???),
or move objects around the feet
thank you for help

best regards
Nicholas

[Markus Zeppenfeld]

Hi Nicholas,

depending on your setup you have to decide if you need more than one camera or a pressure detection by walking above or other tracking options.
The motion detection or maybe the collision panel could be a good option for you to realize your application again depending on what exactly you are planning to do.

Markus

[niky]

Hi Markus,
thank you for your help ,
in case what kind of pressure detector compatible can i use?

regards
Nicholas

[Markus Zeppenfeld]

Hi!

At the moment I can't advice you a pressure detector as I do not have experiences on these kinds of sensors myself.
So far I only used a Wii-Balance-Board.

Maybe somebody else has experiences on this!?

Markus

[rubendesnoo]

You should look at a pressure sensor, under each feet/leg of a stage. With the sensorlink the values could be red by widget designer, and then you could calculate a position.
I think there are also sensors with a module which you could program to send tcp/udp-values.

regards