Widget Designer with FX

[craigreilly]

On a DualServer, I have 2 images side by side filling an area, i.e.: 3840x1920.
The surface is a moving wall.
Without using TrackScan - can I use WD Pro to crop these 2 images as the wall "opens"

| WALL 1 <-- CROP || CROP --> WALL 2 |


Thanks in advance.

[Martina Protze]

Hi Craig,
there are several ways and sensors, to achieve that. How do you tell WD that the wall opens and how fast the two parts move? or is *that* the point you are actually asking?

[craigreilly]

i think we got it figured out. We were using Crop Edges|Right on one fader and Crop Edges|Left on another fader in WD Pro. The problem was not changing the MAx value to 65535 - so it was moving just 255 pixels. It was working we couldn't see it.
Then we added a button to change both WD Faders (#1 and #2) to FadeUp or Down over 10 seconds. The timing will be critical... but we'll get it.

We set 2 faders to control the output layers so it would not matter what layer we were on - anything would crop when we needed it to.

to close
WDFaderAbortFade,1
WDFaderAbortFade,2
WDFaderDown,1,10
WDFaderDown,2,10

to open
WDFaderAbortFade,1
WDFaderAbortFade,2
WDFaderUp,1,10
WDFaderUp,2,10