WD and IMAGE Pro II

[Daniel Kaminski]

Here is how you change Inputs on a Image Pro II

Create TCP Connection in the Connection Manager
Connect to Port: 10001

TCPSEND,TCP Connection ID,RTE 4[CR LF]

This will change the Input to Input 4 - Displayport
This was tested here on Firmware 2.50.06

A list of command supported by the Image Pro II can be found in the Image Pro II Manual which is available on the BARCO Website.

[honsbeek]

Heey thanks,

I Will try soon with

- barco matrix 8x dvi
- barco com HD8

[JustynR]

I am in the middle of making a very involved Widget with a couple of Barco Matrix 8x DVI units.

The connection port for the Matrix Switcher is: 23.

I am currently making a Widget that will automatically switch 2 sources at a time to take over a failed Dual Player.
That's the easy part, once it has switched, the failed computer is rebooted and then once the Client is running it becomes that backup.

I've run into a few challenges, but so far so good... I'll share my results when I'm done.

Cheers