Page 1 of 1

Assign fader parameter and devices from wd

PostPosted: Sat Aug 16, 2014 3:13 pm
by alverman
Is there a command to assign a fader to the field devices and parameter from WD?
Is there a command to add an effect to a layer from WD?

Thank you, Alberto

Re: Assign fader parameter and devices from wd

PostPosted: Sat Aug 16, 2014 5:24 pm
by alverman
alverman wrote:Is there a command to assign a fader to the field devices and parameter from WD?


For these two I solved dusting off an old debate open to me :roll: lost my memory
viewtopic.php?f=80&t=1794&p=5763&hilit=fader+parameter#p5763

While I have not found solutions for this
Is there a command to add an effect to a layer from WD?

Thank you, Alberto

Re: Assign fader parameter and devices from wd

PostPosted: Mon Aug 18, 2014 11:37 am
by alverman
Good Morning.
I'm trying to do a project dynamic, in the sense that every object that refers to a layer can be set dynamically.
I've created a page where you set through the ecoder, the devices (layer) and then by the script will be assigned to the objects of my project that will act on that layer.
So I proceed in programming but often I get to a point where something is always missing that makes me stranded and puzzled to find an alternative solution to the lack of that feature. At this time I am referring to the inability to dynamically assign the value in the xy Panel devices, but here there is no alternative
now I'm stuck and demoralized

Alberto