Pandoras Box User Forum

Hello. I am attempting to use mouse control with AirScan. My touch points read accurately on a multi-touch panel with AirScan enabled, and my WD page has an AirScan touch overlay, so I can see that each of my touch points for those purposes are accurate. However, when I enable mouse control, the mouse is offset by (rough estimate) 200px to the right and 50px down. I have not adjusted any sort of x-y offsets in AirScan properties, so I don't know why this is? How is it that I have all of my touch points EXCEPT mouse control properly calibrated? Thanks in advance for your help!

- Rob