RS485 connection
Posted: Mon Nov 16, 2015 10:53 am
Hello!!
I am planning to use WD to control a motor that controls a screen.
so I am thinking of using Arudino between the motor and WD to enable serial communication between the devices.
Due to the fact taht the motor only supports RS485 connection, I fee like I have to follow it. Additionally
I am a beginner when it comes to serial communication.
In order to make the system that I mentioned , I am wondering if WD supports RS458 serial.0
The manual only mentions RS232/422 not 485. I might be worried about it too much.
It is possible to make the system?
If so, What command or node should I use to send signal to an Arduino ??
Any help would be helpful to me.
thanks in advance.
-Kurt-
I am planning to use WD to control a motor that controls a screen.
so I am thinking of using Arudino between the motor and WD to enable serial communication between the devices.
Due to the fact taht the motor only supports RS485 connection, I fee like I have to follow it. Additionally
I am a beginner when it comes to serial communication.
In order to make the system that I mentioned , I am wondering if WD supports RS458 serial.0
The manual only mentions RS232/422 not 485. I might be worried about it too much.
It is possible to make the system?
If so, What command or node should I use to send signal to an Arduino ??
Any help would be helpful to me.
thanks in advance.
-Kurt-