by proximityav » Sat Mar 26, 2016 8:35 am
Hey Drew!
Hope all is well mate.
I can connect and control via a Telnet session on port 9878 no problem. In WD I can connect on the same port but not control.
I'm using the same kind of syntax I've used with before with encore, SPII and PDS with the protocol stated in the event master manual. For example:
TCPSend,x,ATRN<CR>
and
TCPSend,x,PRESET -r1<CR>
where x is my TCP connection manager number. I've tried variations of brackets, spacing etc...
I only had a few hours with an actual e2 system to test this after an event with no luck. I'm mainly testing now with the Simulator. Telnet commands work with the sim no problems.
Cheers
Paul R