TUIO Touch Output on Port 3333
Posted: Tue Jun 21, 2016 6:39 pm
Hello all,
I am trying to send TUIO touch / point information from widget designer. Here is where I currently am. I have enabled TUIO in the connection manager, from IP (widget designer computer) 2.0.0.8 on port 3333. I assume that the TUIO enable sends out via UDP on 255.255.255.255. I have opened Camera Tracker and under Touch Output Processing, I have enabled TUIO Output. I am running the camera in B/W and have it set for a single point. I can move my hand around, and it puts an identifier of 1 on my hand. At this point, I would assume that I should start seeing TUIO data being streamed out on port 3333. But Wireshark sees nothing getting sent out. I have tested wireshark with a packet tester.
Also, I have Multi Touch Panel open within widget designer, I see a selection for TUIO input, but not anything to output the touch interaction.
Am I covering all my bases? Or am I missing something.
Just for testing purposes, I have created a UDP Connection as ID 1, for port 3333, and can successfully send UDPSend,1,Do something cool via the network, and wireshark sees this transmission on several different computers.
I Have been to TUIO.org and read through some documentation, a basic TUIO network bundle might look like this when transmitting data for a two dementional cursor profile from what I've read:
/tuio/2Dcur source application@address
/tuio/2Dcur alive s_id0 ... s_idN
/tuio/2Dcur set s_id x_pos y_pos x_vel y_vel m_accel
/tuio/2Dcur fseq f_id
Thanks for your insight on any of this, And Thanks in advance for the help!!
Have a great week everyone.
I am trying to send TUIO touch / point information from widget designer. Here is where I currently am. I have enabled TUIO in the connection manager, from IP (widget designer computer) 2.0.0.8 on port 3333. I assume that the TUIO enable sends out via UDP on 255.255.255.255. I have opened Camera Tracker and under Touch Output Processing, I have enabled TUIO Output. I am running the camera in B/W and have it set for a single point. I can move my hand around, and it puts an identifier of 1 on my hand. At this point, I would assume that I should start seeing TUIO data being streamed out on port 3333. But Wireshark sees nothing getting sent out. I have tested wireshark with a packet tester.
Also, I have Multi Touch Panel open within widget designer, I see a selection for TUIO input, but not anything to output the touch interaction.
Am I covering all my bases? Or am I missing something.
Just for testing purposes, I have created a UDP Connection as ID 1, for port 3333, and can successfully send UDPSend,1,Do something cool via the network, and wireshark sees this transmission on several different computers.
I Have been to TUIO.org and read through some documentation, a basic TUIO network bundle might look like this when transmitting data for a two dementional cursor profile from what I've read:
/tuio/2Dcur source application@address
/tuio/2Dcur alive s_id0 ... s_idN
/tuio/2Dcur set s_id x_pos y_pos x_vel y_vel m_accel
/tuio/2Dcur fseq f_id
Thanks for your insight on any of this, And Thanks in advance for the help!!
Have a great week everyone.