Page 1 of 1

Clarification on the Delta Node

PostPosted: Wed Jan 11, 2017 10:53 pm
by chrisr
All, last month I had asked for some help with prediction with some automation. All the help was greatly appreciated and the end product turned out really nice. Thanks again for all the help.

I wanted to ask for a bit of clarification to make sure I understood what is written in the Help Document Rev13338.

17.4.6.5 DELTA

Filter Properties:
Input:
Choose input node from list or enter numeric value.

Range:
Enter maximum value if incremental values are used to calculate correct delta values between the start
and end value.
You will need this for example when using encoders from 0 to 1439.

-------

IF my input range is a 16bit DMX source 0-65,536 would the delta range be set at 65,536?
As I understand it, the max value is used to calculate correct delta values.

Image



Thanks again! Have a good week.