Page 1 of 1

Controlling Blackmagic ATEM switcher?

PostPosted: Sun Feb 26, 2017 1:04 pm
by pianist
Dear Forum!

Would I be able to control a Blackmagic ATEM TV Studio HD from WD through TCP?

All the best,
Jacob

Re: Controlling Blackmagic ATEM switcher?

PostPosted: Mon Feb 27, 2017 10:52 am
by Thomas Mrozek
Hi Jacob,
if this device can use TCP/serial commands it is possible. There is software and sdk available, so it should.

Re: Controlling Blackmagic ATEM switcher?

PostPosted: Wed Mar 01, 2017 5:47 pm
by pianist
Thanks!

Here is a workflow I just discovered, but it requires you to have a Mac running Isadora (or equivalent) on your network:

I found this piece of MAC-only software which will make the bridge between any OSC transmitting software (in this case Isadora) and ATEM switchers https://www.buechele.cc/blog/2013/2/5/a ... -switchers This will let me control ATEM switchers easily.

Then I just need to set up a TCP connection from WD where custom script buttons will then trigger the corresponding ISADORA actors.

Jacob