All, hope you are well.
And thanks for any insight on this question. I've read through the forum, and specifically didnt find anything that answered what I was looking for. I am using OSC to control a 3rd party application successfully via the OSC output node. So the straight forward command structure works great. For example : /layer1/clip1/opacity/values , which has a floating value or ,f . I am wondering how does one produce a string that says I'm an OSC transmission. I've tried the obvious UDPSend,1,/layer1/clip1/opacity/values, but where I am obviously failing is this string needs to be defined, as well as the floating value needs to be defined. Understanding that OSC commands are sent in multiples of 32 bits 4, 8 bit bytes. When I try to use UDPSend its not doing the back end work that the node is doing. My question is, if I wanted to format a string command after the UDPSend. What would it look like? Below is a successful string out of TouchOSC:
https://hexler.net/software/touchosc
, this has a floating value you see at the bottom.
So basically just curious if anyone has successfully sent OSC with a UDPSend command. I've read through http://opensoundcontrol.org/spec-1_0 website. Its has provided useful information but I'm still struggling.
Have a great weekend everyone.