a) Connect DVI Matrix to your Network
b) Assign the DVI Matrix an IP Adresse in the same Subnet as your WD
c) Start your WD
d) open the Connection Manager (Right Click, Tools, Connection Manager)
e) add a TCP Connection
- Client Only
- Name: Matrix
- IP: DVI Matrix IP Adress
- Port: normaly 23 (unless you have changed it inside the Matrix Configuration)
Now you are done. WD Designer is now Connected to the Matrix and ready to send comands:
Commands will look like this:
TCPSend,'ID','Message'
'ID'
The TCP Connection ID out of the Connection Manager
'Message'
Valid 'Message' are:
{ii@oo}
Change Routing: Input ii @ Output oo
Example:
TCPSend,1,{1@3}
Connect Output 3 to Input 1.
{ii@O}
Change Routing: Input ii @ ALL Outputs
Example:
TCPSend,1,{1@O}
Connect All Output to Input 1.
Daniel