Hello All.
I am putting together a work around for a project. I have a system that has two Christie Captiva Ultra short throw projectors connected and being controlled by the widget. I also have a crestron controller in line to convert the audio file to 7ch. We were planning on also using the Crestron to turn off the projectors at certain times as well as if the fire alarm is trigged. Originally we were going to talk directly to the projectors from crestron thru the network. However since the network is also connected to the widget and since the crestron is constantly requesting status from the projectors (can not be adjusted) the network port on the projector locks up.
Since we are able to control the projectors from the widget I am looking at how to receive a TCP command from the crestron and once widget sees that string to fire a command to turn off or on the projectors depending on the string sent from crestron.
I have set up a TCP connection in the widget to the crestron
We had a cutom module built to send "Projectors Off" and "Projectors On" from the crestron at specific times we determine or when a contact closure is tripped or released.
I am assuming I need to use a TCP input node but haven't been able to make it work.
Any suggestions would begreat.
Cheers.
Eric Ludacer